Perfect Hay

This 2006 Dodge Ram 2500 Cummings Turbo Diesel gets excellent mileage[18-22 on interstate and never below 16-18 just driving around town. I just put new tires on it about 3000-4000 miles ago and shortly after that I installed a brand new original equipment electric seat. The windshield had several really tiny chips in it from the 135K miles so I replaced it also thinking I was going to at least keep this nice pickup for another100,000 miles as I'm 70 years old but very active yet and didn't think I needed a newer one yet. But then I found a 2010 model just like this with only 16,000 miles on it with 4 doors and I now have three Grandchildren that I like to take along so I will sell this one as soon as I get this other one home.
This one has a J & I Manufacturing Flat-bed on it [a very nice heavy duty custom made for this pickup] with six lockable tool boxes on it and side rails with the GN ball hitch under a hinged lid. The receiver hitch and spare tire are on it under the rear of the bed. It has always been inside my garage in town here but gets left outside during the daytime when I am using it. It has a chrome grill guard and running boards on it. I remember paying $4300.00 for the flat-bed when I had it installed when I bought the pickup new in 2007. I am the only owner and I have always had it serviced [by the book] at the local service station here in Bloomfield, Ne.
Right now I am trying to get time to brush paint a rust resistant coating on the flat-bed so I can give it another touch-up coating of black. I also have new hinges [stainless steel grease able ones] to install onto the 4 lower toolboxes. The original ones are getting road grime chemicals into them and they are getting more sticky all the time and should be replaced. I may not get time to do all this to it but I will give all the material and parts to who-ever wants this pickup when they buy it. I will need time to clean out the cab and all the tool boxes when someone buys it as I use it every day. I am planning on a trip to Oklahoma the week of Feb. 13-18 with this pickup to go pick up my other one so it will be gone then. I'll be in the Idabel, Ok. area and Madill, OK. area for these days if someone from that area see's it they can get it from there.
An awfully lot of people [young and old] have tried to buy this good looking pickup from me ever since I have had it so now is there chance. I have priced it to several people at $25,000.00 just as it sets but will accept what ever the highest offer is as soon as I get my other one home or if someone gives me a good check for it while I am in Oklahoma. My cell# is 402-640-1306. My name is "Noly Poppe"

	This 2006 Dodge Ram 2500 Cummings Turbo Diesel gets excellent mileage[18-22 on interstate and never below 16-18 just driving around town. I just put new tires on it about 3000-4000 miles ago and shortly after that I installed a brand new original equipment electric seat. The windshield had several really tiny chips in it from the 135K miles so I replaced it also thinking I was going to at least keep this nice pickup for another100,000 miles as I'm 70 years old but very active yet and didn't think I needed a newer one yet. But then I found a 2010 model just like this with only 16,000 miles on it with 4 doors and I now have three Grandchildren that I like to take along so I will sell this one as soon as I get this other one home. This one has a J & I Manufacturing Flat-bed on it [a very nice heavy duty custom made for this pickup] with six lockable tool boxes on it and side rails with the GN ball hitch under a hinged lid. The receiver hitch and spare tire are on it under the rear of the bed. It has always been inside my garage in town here but gets left outside during the daytime when I am using it. It has a chrome grill guard and running boards on it. I remember paying $4300.00 for the flat-bed when I had it installed when I bought the pickup new in 2007. I am the only owner and I have always had it serviced [by the book] at the local service station here in Bloomfield, Ne. Right now I am trying to get time to brush paint a rust resistant coating on the flat-bed so I can give it another touch-up coating of black. I also have new hinges [stainless steel grease able ones] to install onto the 4 lower toolboxes. The original ones are getting road grime chemicals into them and they are getting more sticky all the time and should be replaced. I may not get time to do all this to it but I will give all the material and parts to who-ever wants this pickup when they buy it. I will need time to clean out the cab and all the tool boxes when someone buys it as I use it every day. I am planning on a trip to Oklahoma the week of Feb. 13-18 with this pickup to go pick up my other one so it will be gone then. I'll be in the Idabel, Ok. area and Madill, OK. area for these days if someone from that area see's it they can get it from there. An awfully lot of people [young and old] have tried to buy this good looking pickup from me ever since I have had it so now is there chance. I have priced it to several people at $25,000.00 just as it sets but will accept what ever the highest offer is as soon as I get my other one home or if someone gives me a good check for it while I am in Oklahoma. My cell# is 402-640-1306. My name is "Noly Poppe"
	Really a nice 7230 "Premium" MFWD, 16 speed Power Quad tractor, with the Left hand reverser. It has the typical little scratch here and there and a few little marks on it as it should with only 3079 hours on it. Brand new Firestone 18.4 R 42's on the rear and matching Firestone 14.9 R 28's on the front.. The JD warranty on this one is good until May 13 of 2012 yet or up too 4000 Hrs. It is a 2008 model. All of the filters, (air) cab, fuel, motor, hydraulic have been replaced with new JD ones. None of these filters were bad but I always make sure on these tractors so they are completely ready to go to work. The motor oil and transmission -hydraulic oil are all changed also. I had discovered a small anti-freeze leak and had it repaired while in the John Deere dealership shop here in Bloomfield, NE. [Northeast equipment (phone number 402-373-4449)] on 12-20-11. This will be covered by JD warranty but there is a $500.00 "deductible" on this and if it should continue to leak this deductible would already be paid and transferred to the next owner and they would not have to pay it again. It appeared to be that o-ring on the bottom of that plastic tank up on top by the radiator and does not leak now. We have tested it and drove it several times and left it set inside on clean cement to determine if it still leaked and it doesn't. There is a small crack in the front of the lower part of the hood and I replaced the plastic rope-like part that keeps the hood from going up too far. (This may have been the reason for the small crack?) The left arm-rest pad was in need of repair so I ordered a new one and if you look really close you can see a tiny hole in the bottom part of the seat pad-typical of a 3000 hr tractor. The Serial number on this one is RW7230H005409 and the selling price of this tractor alone is $78,000.00 with no trade-ins. I have installed a brand new 110 volt engine block heater and it setting in my shed here in Bloomfield, NE. plugged in and ready to go to work. I am installing a "BRAND NEW" 740 loader here with a BRAND NEW 8 foot bucket and a BRAND NEW 5-tine grapple fork. This will be an "IDEAL" loader for this MFWD . I now have put the front fenders on this tractor and they fit perfectly, But I am not sure the fenders can stay on or not once the 740 loader has been put on it. The new price of this one now with the loader and all the attachments will total up to $93,000.00. I have a work sheet order showing everything we have had done to this one too and will try soon to get all the sheets onto the web in the next week or so .I’ll also get another bunch of pictures of it with the loader mounted on it soon. The $93,000.00 May seem a little high priced to some people , But only adding $15,000.00 to the tractor price hardly covers the cost of the 740 loader once it got installed. Northeast equipment did all the work and I made sure all the best was done to it [like the 3-4 function joystick added without disturbing the three sets of hydraulic outlets on the rear of this tractor]. Therefore you can operate the tractor and loader [grapple fork included] with the joy stick while also shifting the Power Quad transmission with your thumb on the rabbit and turtle buttons. All of this can be done with any type of round bale processor hooked to the rear of the tractor using any of the three open hydraulic SCV outlets. This makes it the "Super" Super" Calving and feeding tractor all serviced and ready to work for the rancher that is putting all those Long, LONG hours of chores saving all those newborn calves and keeping all those Mama cows healthy and Happy. Please notice the extra rear weights I have on hand also that could still be added the cast rear wheels if you would deem them necessary. John Deere has discontinued making the 740 and 741 loaders about a month or two ago, Therefore this all brand new 740 loader is a rare find along with all the proper additional attachments needed. There is two different work orders show local work done on this tractor. Click here to open a new window with the PDF file of the work order for the work I had done at my local JD dealership. Click here to open a new window with the PDF file of the work order for the work I had done at my local JD dealership. Or click on these pictures #1 #2
Pictures with Duals and Wheel Weights	Almost a brand new tractor yet 2009 7330 Standard MFWD with only 400 hours I have duals and wheel weights on hand for this. This 2009 Standard 7330 is almost new yet, some of the plastic still is shown on the seat yet and the Hour meter is only showing about 470 hours. It has matching Firestone tires on it that only show the 470 hrs the tractor has on it. 14.9 R46 rears and 30 inch rubber on the front, with Hub mounted duals and tires to match these.. The tractor has one set of 450# rear weights on the inside of the rear wheels and 10 front weights on the front weight bracket. It is a 16 speed Power Quad transmission with the "Left-Hand Reverser" This one has 2 doors, a "Buddy Seat" Radio, Corner exhaust, Front fenders, and 3 sets of auxiliary hydraulic outlets on the rear of the tractor. About the only thing I can see on it that is not exactly the same as a 7330 premium is the decal itself and a few more lights. It is really equipped properly and I suspect I won't have it very long either as the last one I got here from the same place was gone within 2 weeks, because these really nice ones that are still under JD warranty are very hard to find. This one's warranty is good yet until Oct 29 of 2014 or 3000 Hours. Our local dealer checked this one out for me and said there was never any warranty claims on it and it is still possible to purchase more coverage if whoever purchases it would desire to do so. The pictures were taken before I could get it all cleaned up and you can see the road scum on the rear window. When it gets back here on one of the hay trucks I will clean all of this up. drive it to the JD dealership for a complete check-up like I always do, and it will be ready to go to work around the first or second week of January in 2012,or sooner? $88,000.00 will buy it if you hurry and have no trade-ins. I will not have to go down in the price of this one because of the great demand I have already!!! The serial number on this one is RW7330H013194. Call my cell# 402-640-1306mailto: or email me at info@perfecthay.com ASAP if you have more questions. Click here to open a new window with the PDF file of the work order for the work I had done at my local JD dealership. Or click on this picture
	JD H360 Loader
	Wheel Weights



About the tractors: I have been in the hay business for a long time. I am 68 years old and have bought and sold a large quantity tractors and farm equipment during my 40 years of farming and producing hay. Because I get these tractors from a friend of mine at a exceptionally reasonable price, I can sell them in the fall at well below usual dealer price for identical tractors with more hours on them You can be very confident in taking advantage of this rare opportunity. Call Nolan Poppe's Cell# 402-640-1306 or Email: Info@PerfectHay.com